Install and run the latest version of the programming software. A screen showing “J8 Programmer” should appear and must be clicked on to select the correct pager to program. When the “Configure” button is pressed, the initial programming screen should show “USB programmer connected” and “NO PAGER” at the bottom left of the display. Configure the programming software for the desired pager settings.
Since the programming connections for the NP35 Pager are in its battery compartment, the pager is programmed or read with the battery door open and no battery present. The NP35 is positioned over the seven programming pins on the fixture with the pager at a slight angle to account for the battery door fitting into the bottom of the fixture. Press the pager down into place and ensure the “Write” and “Read” buttons in the programming software are active. The “NO PAGER” indication should change to “PAGER INSERTED”. Continue holding the NP35 in place to perform the programming.
